Case IH Steiger 370 CVT Service Manual page 413

39. Starting with a steel separator plate, alternately install
4 separator plates and 3 friction plates. Be sure the
slots in the ears of the separator plates engage the
dowel pins.
Go to Step 41.
NOTE: Soak the friction plates in clean operating fluid be-
fore installation.
40. Install the splined side gear on top of the pinion gears
so that all gears are in mesh.
41. Lubricate the large thrust washer with clean assembly
grease. Install the thrust washer into the cover (tab
side down).
Front axle system - Front bevel gear set and differential
48193194 12/10/2017
25.2 [25.102] / 299
40
RCPH10FWD049ABJ
41
RCPH10FWD047ABJ
42
RCPH10FWD006ABJ