Table of Contents
Advertisement
12
1.2 Basic usage
No.
0
1
2
1.3 Electrical parameters
No.
1
2
3
4
5
6
7
8
9
10
11
12
Pin status
indication
According to different working states, with different pin level
prompt
For more features, please see the
related application documentation
Usage
Description
Module No. 1 is set to AP mode and establishes a TCP or UDP server,
Module to
Module No. 2 is set to STATION mode and connects to AP No. 1, and
Module
communicates with Module No. 1 through TCP or UDP Client mode.
Communication
Communication with module 1 through TCP or UDP Client
The Wi-Fi module is connected to the network through the wireless
Module
to
router and communicates with the server on the network (LAN or
Server
Internet) via TCP Client or UDP.
Commun
If you need to connect to an Internet server, you need to configure the
ication
router with the appropriate port mapping.
Module-to-Cl
The Wi-Fi module connects to the network through the wireless router
and establishes a TCP or UDP Server to listen for connection signals.
ient
The Client communicates with it through the Connection Module
Commun
Server.
ication
For more features, please see the related application documentation
Paramet
Parameter Value Comments
er Name
RF Chips
CC3200
Module
27 * 19 * 2.7mm
Size
Average
2.2g
Weight
PCB
4 layers
Process
Operatin
2.4~2.484 GHz
g
Frequenc
y Band
Producti
Lead-free process,
on
machine paste
Process
Interface
1.27mm
Method
Power
2.4 ~ 3.6V DC
supply
voltage
Commun
Maximum 3.6
ication
level
About 150m
Measured
About 500m
distance
Transmit
20dBm
ting
power
AT
Built-in intelligent
processing
Support
TI
PCB antenna included
PCB Antenna Included
Impedance Debugging
Wireless products must be machine-mounted to ensure
batch consistency and reliability
SMD
Note: Voltage higher than 3.6V will cause permanent
damage to the module
It is recommended that the difference with the supply
voltage is less than 0.3V to reduce power consumption
Clear and open, maximum power, height 2m
Clear and open, maximum power, height 2m
About 100mW
Configuration parameters can be set or read via AT
commands
Advertisement
Table of Contents
