Wireless Remote Configuration Function; Function Parameter Description - Ebyte JN5189 User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd.

6.2 Wireless remote configuration function

The module supports the remote configuration function, which is identified by the two-byte wireless configuration ID by
default as A8 8A. The user can modify the remote configuration ID of the module. When the first two bytes of the
wireless air data received by the module are the wireless configuration ID, The module judges that the data packet is a
remote configuration command and executes the operation corresponding to the command. The data packet will not be
output through the serial port. The remote configuration of the dormant terminal needs to wake up first.

6.3 Function parameter description

The module provides a wealth of configurable parameters, which can be used flexibly according to actual application
requirements to construct different forms of networks.
Configurati Attributes
on
informatio
n
PANID Read/Write
Local Read
network
address
Network Read
status
Destination Read/Write
network
address
Local MAC Read
address
Destination Read/Write
MAC
address
Equipment Read/Write
Copyright ©2012–2021，Chengdu Ebyte Electronic Technology Co.,Ltd.
Parameter range
0x0000～0xFFFF
PANID is the network identifier of ZIGBEE, which is
used to determine the identity of the network to which it
belongs. The PANID of all devices in the same network
must be the same. When the terminal or router is
configured as 0xFFFF, it can join any network where
the same channel already exists;
0x0000～0xFFFF
It is used to distinguish each node in the network. Each
device is in the same network. The local network
address must be unique. When not joining the network,
the network address of the device is 0xFFFF. After
joining, the short address of the device is assigned by
the coordinator. The coordinator is fixed as: 0x0000;
0、2、3
Indicates the network status of the current device,
including no network, has successfully joined the
network, there is a network without a parent node;
0x0000～0xFFFF
The current device communication target (short address)
can be switched at any time through configuration
commands;
64bitMAC The MAC address allocated by the network of this
module cannot be changed by the user (re-entry to the
64bitMAC In fixed-point mode, use long address to send
C、R、E、S
They are: coordinator, router, non-sleeping terminal,
Function Description
network to change)
E180-Z8910SP User Manual
16