Ebyte E103-W02 User Manual page 17

Serial wifi smd small volume pcb antenna mqtt

Hide thumbs Also See for E103-W02:

Table of Contents

⑦ . Reset or power down to restart the module, if the WiFi module is far away from the module, please connect the

antenna.

⑧. If LED1 is lit (GPIO9 pulled low), it indicates that the access to WiFi hotspot is successful.

Module as STA (Station) to connect to other WiFi hotspots via SmartConfig (one-click configuration)

①. Connect the factory E103-W02 base board to the PC via Micro USB cable.

②. Open the serial debugging assistant "AccessPort" and select the port number; if you don't know the port number,

please check it in the device manager (see the figure below).

Table of Contents