Axis Number Setting - Mitsubishi Electric FR-A8NS Instruction Manual

2.3

Axis number setting

Set the axis number between 0 to F using the axis number switch (refer to
The setting is applied at the next power-on or inverter reset.
Set the switch marked with an arrow ( ) to the axis number (0-9, A-F) corresponding to the desired axis.
Axis number Definition
0 (initial status) 1st axis
1 2nd axis
2 3rd axis
3 4th axis
4 5th axis
5 6th axis
6 7th axis
7 8th axis
NOTE
• Do not change the axis number while the inverter power is ON. Otherwise you may get an electric shock.
• Set the axis number switch with precision so that the arrow on the switch points just a number or letter position. If the switch
is set between numbers, normal data communication cannot be made.
• You cannot set the same axis number to other devices on the network. (Doing so disables proper communication.)
28
INSTALLATION
Axis number Definition
8 9th axis
9 10th axis
A 11th axis
B 12th axis
C 13th axis
D 14th axis
E 15th axis
F 16th axis
Good
example example
0
page 13) on the FR-A8NS.
Bad
0