2.2
Installation procedure
Installation of the FR-A8NS
1.
Fit the board mounted option connector on this product to the guide of the option connector on the inverter, and insert the
option as far as it goes. (Attach this product to option connector 1 on the inverter.)
2.
Fasten this product to the inverter using the two mounting screws through the holes on either side (tightening torque: 0.33
to 0.40 N∙m). If the screw holes do not line up, the connector may not be inserted deep enough. Check the connector.
• Example of installation to connector 1
Option connector
on the inverter
INSTALLATION
2
21