Table of Contents
Advertisement
For correct and safe lifting operations:
• use the type of equipment most suitable for characteristics
and capacity (e.g. electric pallet truck or lift truck);
• cover sharp edges;
• check the forks and lifting procedures according to the
instructions given on the packing.
D.3.2
Shifting
The operator must:
• have a general view of the path to be followed;
• stop the manoeuvre in case of hazardous situations.
D.3.3
Placing the load
• Before placing the load, make sure the way is free and that
the floor is flat and can take the load.
• Remove the appliance from the wooden pallet, move it to
one side, then slide it onto the floor.
D.4
Storage
The machine and/or its parts must be stored and protected
from damp, in a non-aggressive place, free of vibrations and
with room temperatures between -10℃ [14℉] and 50℃
[122℉].
The place where the machine is stored must have a flat
support surface to avoid deforming the machine or damage to
the support feet.
E
INSTALLATION AND ASSEMBLY
WARNING
Refer to "Safety Information".
E.1
Introduction
WARNING
Make sure that the switch disconnector of the
machine is locked in the Off position - "O".
E.2
Customer responsibilities
The Customer must provide for the following:
• installation of an adequate electrical power supply ahead of
the appliance, according to the equipment's technical
specifications (C TECHNICAL DATA and C.2 Character-
istics of power supply);
• the equipotential connection
system to the metal structure of the machine by means of a
copper cable of adequate section (see position "EQ" in
Installation diagram);
• adducting for the electrical connection between the work-
place electric panel and the equipment;
• the water supply and drain connections and other con-
nections as indicated in C TECHNICAL DATA and in the
paragraph E.8 Plumbing connections;
E.3
Machine space limits
• A suitable space must be left around the machine (for
operations, maintenance, for a correct air exchange, etc.).
• This space must be increased in case of use and/or transfer
of other equipment and/or means or if exit routes are
necessary inside the workplace.
of the workplace electrical
CAUTION
Do not make modifications to the parts
supplied with the appliance. Any missing
or faulty parts must be replaced with
original parts.
D.5
Unpacking
IMPORTANT
Immediately check for any damage caused during
transport.
Inspect the packaging before and after unloading.
1. Remove the packaging.
Take care when unpacking and handling of the appliance
to not cause any shocks on itself.
2. Keep all the documentation contained in the packaging.
Note
• The forwarder is responsible for the goods during transport
and delivery.
• Make a complaint to the forwarder in case of visible or
hidden damage.
• Specify any damage or shortages on the dispatch note.
• The driver must sign the dispatch note: the forwarder can
reject the claim if the dispatch note is not signed (the
forwarder can provide the necessary form).
• For hidden damage or shortages becoming apparent only
after unpacking, request the forwarder for inspection of the
goods within and no later than 15 days after delivery.
CAUTION
Install the machine at a distance of not
less than 50 mm from the wall so as not to
affect
correct
components.
CAUTION
For the machine with ESD, make sure that
the distance from the ceiling is not less
than 300 mm.
ventilation
of
internal
17
Advertisement
Table of Contents
