D.2
Transport: instructions for the carrier
WARNING
Do not stand under suspended
loads during loading/ unloading
operations. Unauthorised per-
sonnel must not enter the work
area.
The weight of the appliance
alone is not sufficient to keep it
steady.
NOTE!
The transported load can shift:
• when braking;
• when accelerating;
• in corners;
• on rough roads.
D.3
Procedures for handling operations
For correct and safe lifting operations:
• use the type of equipment most suitable for characteristics
and capacity (e.g. electric pallet truck or lift truck);
• cover sharp edges;
Before lifting:
• send all operators to a safe position and prevent persons
from entering the handling area;
• make sure the load is stable;
• make sure no material can fall during lifting. Manoeuvre
vertically in order to avoid impacts;
• handle the machine, keeping it at minimum height from the
ground.
WARNING
For machine lifting and anchor-
ing, do not use movable or weak
parts such as: casings, electrical
raceways, pneumatic parts, etc.
E
INSTALLATION AND ASSEMBLY
E.1
Introduction
To ensure correct operation of the appliance and maintain safe
conditions during use, carefully follow the instructions given
below in this section.
WARNING
The above operations must be
carried out by the specialised
personnel in conformity with the
current
regarding the equipment used
and the operating procedures.
Before moving the appliance
make sure the capacity of the
lifting equipment used is suitable
for its weight.
safety
regulations,
D.4
Shifting
The operator must:
• have a general view of the path to be followed;
• stop the manoeuvre in case of hazardous situations.
WARNING
Do not push or pull the appliance
to move it, as it may tip over.
D.5
Placing the load
Before placing the load, make sure the way is free and that the
floor is flat and can take the load. Remove the appliance from
the wooden pallet, move it to one side, then slide it onto the
floor.
D.6
Storage
The machine and/or its parts must be stored and protected
from damp, in a non-aggressive place, free of vibrations and
with room temperatures between -10℃ and 50℃. The place
where the machine is stored must have a flat support surface
to avoid deforming the machine or damage to the support feet.
WARNING
Appliance positioning, installa-
tion and disassembly must be
carried
out
personnel.
CAUTION
Do not make modifications to the parts
supplied with the appliance. Any missing
or faulty parts must be replaced with
original parts.
E.2
Customer responsibilities
The Customer must provide for the following:
• installation of an adequate electrical power supply ahead of
the appliance, according to the equipment's technical
specifications (C.1 Main technical characteristics and C.2
Characteristics of power supply);
• the equipotential connection
system to the metal structure of the machine by means of a
copper cable of adequate section (see position "EQ" in
Installation diagram);
• adducting for the electrical connection between the work-
place electric panel and the equipment;
• the water supply and drain connections and other con-
nections as indicated in C.1 Main technical characteristics
and in the paragraph E.8 Plumbing connections;
E.3
Characteristics of the installation place
The machine is designed for installation in professional and
not domestic-type kitchens. Water collection traps/ metal
grates must be arranged in the floor at the machine discharges
(see the Installation diagram), possibly replaceable with a
single water trap sized for a flow rate of at least 3 l/s.
by
specialised
of the workplace electrical
13