Table of Contents
Advertisement
G
COMMISSIONING
G.1
Preliminary checks, adjustments and
operational tests
Before starting the machine, check:
1. electrical and plumbing connections;
2. positioning of tank components;
3. washing and rinse arms position and fitting;
4. curtains position and fitting.
These operations must only be carried out by specialized
technicians provided with adequate personal protection equip-
ment (refer to A.3 Personal protection equipment), tools and
suitable ancillary equipment with the machine switched off and
cold.
G.2
Electrical and plumbing connection
Before starting the machine, check:
1. correct connection of the electrical wires that feed the
machine;
2. the power supply voltage and frequency match the data
given in the technical data table (C TECHNICAL DATA);
3. correct connection of the water supply and drain pipes
(E.8 Plumbing connections);
4. guards, safety devices and emergency switches are in
place and properly installed.
G.3
Positioning and fitting of the tank
components
Before starting the machine, check the fitting of filters and
overflows of:
1. prewash 22" module, if present;
5
3
4
2
1
2. prewash 35" module, if present;
5
3
4
1
2
3. wash module;
5
3
4
1
2
G.4
Positioning and fitting of the washing
and rinse arms
Before starting the machine, check the fitting of upper and
lower arms of:
1. prewash 22" module (if present);
2. the arms of prewash 35" (if present) and wash module;
27
Advertisement
Table of Contents
