Table of Contents
Advertisement
F
TRANSPORT, HANDLING AND STORAGE
F1
Introduction
Transport (i.e. transfer of the machine from one place
to another) and handling (i.e. transfer inside work-
places) must occur with the use of special and ade-
quate means.
The machine must only be transported, handled and
stored by qualified personnel, who must:
-
have specific technical training and experience;
-
have knowledge of the safety regulations and appli-
cable laws in the relevant sector;
-
have knowledge of the general safety rules;
-
be able to recognise and avoid any possible hazard.
F1.1
Transport: Instructions for the carrier
ATTENTION!
Do not stand under sus-
pended loads during load-
ing/unloading
Unauthorised
must not enter the work
area.
ATTENTION!
The machine's weight alone
is not sufficient to keep it
steady.
The transported load can shift:
-
when braking;
-
when accelerating;
-
in corners;
-
on rough roads.
F2
Handling
Arrange a suitable area with flat floor for machine
unloading and storage operations.
F2.1
Procedures for handling operations
For correct and safe lifting operations:
•
use the type of equipment most suitable for charac-
teristics and capacity (e.g. electric pallet truck or lift
truck);
•
cover sharp edges;
•
check the forks and lifting procedures according to
the instructions given on the packing.
Before lifting:
•
send all operators to a safe position and prevent
persons from entering the handling area;
•
make sure the load is stable;
•
make sure no material can fall during lifting, and
manoeuvre vertically in order to avoid impacts;
•
F2.2
The operator must:
•
•
F2.3
Before placing the load, make sure the way is free and
operations.
that the floor is flat and can take the load.
personnel
F3
The machine and/or its parts must be stored and pro-
tected against damp, in a non-aggressive place free of
vibrations and with ambient temperature between -
10°C / 14°F and 50°C / 122°F.
The place where the machine is stored must have a
flat support surface in order to avoid any twisting of the
machine or damage to the support feet.
handle the machine, keeping it at minimum height
from the ground.
ATTENTION!
For
machine
anchoring, do not use mov-
able or weak parts such as:
casings,
electrical
ways, pneumatic parts, etc.
Shifting
have a general view of the path to be followed;
stop the manoeuvre in case of hazardous situa-
tions.
Placing the load
Storage
ATTENTION!
Machine positioning, instal-
lation
and
must be carried out by a
specialised technician.
ATTENTION!
Do not make modifications to the parts
supplied with the machine. Any miss-
ing or faulty parts must be replaced
with original parts.
lifting
and
race-
disassembly
13
Hide quick links:
Advertisement
Table of Contents
