Table of Contents
Advertisement
Electrical models (cont'd.)
Model
Rinse water
l/h
consumption
Boiler capacity
l
Tank capacity
l
dB(A)
Noise level
Protection level
1.
Appliances with 50 Hz or 60 Hz power frequency can be selected.
2.
Recommended cold water supply temperature 10℃
3.
Recommended hot water supply temperature 50℃.
*means low power model
Main ON/OFF switch (residual current circuit breaker)
Max power
[KW]
C
380V
Power supply cable
Max power
[KW]
S
D.2
Characteristics of power supply
The AC power supply to the machine must meet the following conditions:
• max. voltage variation ± 6%
• max. frequency variation ± 1% continuous ± 2% for a short period.
Harmonic distorsion, unbalanced three-phase supply voltage, voltage pulses, interruption, dips and the other electric character-
istics must respect the provisions of point 4.3.2 of Standard EN 60204-1 (IEC 60204-1).
E
TRANSPORT, HANDLING AND STORAGE
WARNING
Refer to "Safety Information".
E.1
Introduction
Transport (i. e. transfer of the machine from one place to
another) and handling (i. e. transfer inside workplaces) must
occur with the use of special and adequate means.
CAUTION
The machine must only be transported, handled and stored
by specialised personnel, who must have:
• specific technical training and experience in the use of
lifting systems;
• knowledge of the safety regulations and applicable laws
in the relevant sectors;
• knowledge of the general safety rules;
• personal protection equipment suitable for the type of
operation carried out;
• the ability to recognize and avoid any possible hazard.
E.2
Transport: Instructions for the carrier
IMPORTANT
The transported load can shift:
• when braking;
• when accelerating;
• in corners;
• on rough roads.
ESR20xxx
300
<70
IPX4
45.8
90
45.8
YJV3*35+2*16
YJV3*35+2*16
YJV3*35+2*10
YJV3*35+2*10
ESR20xxx3
300
23
90
<70
IPX4
50.3
100
50.3
YJV3*35+2*16
YJV3*35+2*10
E.3
Handling
Arrange a suitable area with flat floor for machine unloading
and storage operations.
CAUTION
The appliances must be handled in the
upright position. If the appliance is
handled in a horizontal position, make
sure to wait a few hours before making it
operational.
E.3.1
Procedures for handling operations
Before lifting:
• send all operators to a safe position and prevent persons
from entering the handling area;
• make sure the load is stable;
• make sure no material can fall during lifting. Manoeuvre
vertically in order to avoid impacts;
• handle the machine, keeping it at minimum height from the
ground.
For correct and safe lifting operations:
• use the type of equipment most suitable for characteristics
and capacity (e.g. electric pallet truck or lift truck);
• cover sharp edges;
• check the forks and lifting procedures according to the
instructions given on the packing.
E.3.2
Shifting
The operator must:
• have a general view of the path to be followed;
• stop the manoeuvre in case of hazardous situations.
NMDSREx
(Optional Accessory）
23
90
<70
IPX4
50.1
100
50.1
YJV3*35+2*16
YJV3*35+2*10
/
23
/
54.6
108
54.6
15
Advertisement
Chapters
Table of Contents
