Required Tools And Materials; Decommissioning And Disposal; Cabling Recommendations - Siemens SIMATIC NET RUGGEDCOM RS8000H Installation Manual

Introduction
1.3 Required Tools and Materials
RS232 Serial Console Port
Communication Ports
1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM RS8000H:
AC or DC power cord (16 AWG)
CAT-5 Ethernet cables
Flathead screwdriver
Phillips screwdriver
4 x #8-32 screws
1.4

Decommissioning and Disposal

Proper decommissioning and disposal of this device is important to prevent malicious
users from obtaining proprietary information and to protect the environment.
Decommissioning
This device may include sensitive, proprietary data. Before taking the device out of
service, either permanently or for maintenance by a third-party, make sure it has
been fully decommissioned.
For more information, refer to the associated "Configuration Manual".
Recycling and Disposal
For environmentally friendly recycling and disposal of this device and related
accessories, contact a facility certified to dispose of waste electrical and electronic
equipment. Recycling and disposal must be done in accordance with local
regulations.
1.5

Cabling Recommendations

All copper Ethernet ports on RUGGEDCOM products include transient suppression
circuitry to protect against damage from electrical transients and conform with
IEC 61850-3 and IEEE 1613 Class 1 standards. This means that during a transient
4
The serial console port is for interfacing directly with the device
and accessing initial management functions. For information
about connecting to the device via the serial console port, refer to
"Connecting to the Device" (Page
Receive and transmit data. For more information about the
various ports available for the RUGGEDCOM RS8000H, refer to
"Communication Ports" (Page
Tools/Materials
17).
19).
Purpose
For connecting power to the device.
For connecting the device to the network.
For mounting the device to a DIN rail.
For mounting the device to a panel.
For mounting the device to a panel.
Installation Manual, 11/2022, C79000-G8976-1022-07
RUGGEDCOM RS8000H