Table of Contents
Advertisement
RUGGEDCOM WIN5151-V-GPS
Installation Guide
5.
Make sure the subscriber station is grounded. For more information, refer to
Subscriber
Station".
6.
Connect the subscriber station to a power source and the network. For more information, refer to
"Connecting Power and
7.
Seal all cable connections. For more information, refer to
Station".
8.
Configure the subscriber station. For more information, refer to
Station".
Section 2.2
Unpacking the Subscriber Station
The following items are included in the RUGGEDCOM WIN5151-V-GPS package:
• RUGGEDCOM WIN5151-V-GPS Subscriber Station
• 2 × Radio Frequency (RF) antenna cables, 5 m (16.4 ft) long
• Pole/wall/tower mounting kit
When unpacking the subscriber station, do the following:
1.
Inspect the package for damage before opening it.
2.
Visually inspect each item in the package for any physical damage.
3.
Verify all items are included.
If any item is missing or damaged, contact Siemens for assistance.
Section 2.3
Required Tools and Materials
The following tools and materials are required to install the RUGGEDCOM WIN5151-V-GPS:
Tools
• Wrench or socket set
• Phillips screwdriver
• Drill with an 8 mm (5/16 in) drill bit
• Wall anchors (if necessary)
Sprays
• Cleaner and de-greaser
• SCC3 conformal coating
• Corrosion protection
Unpacking the Subscriber Station
Data".
Section 2.7, "Grounding the
Section 2.9, "Weatherproofing the Subscriber
Section 2.10, "Configuring the Subscriber
Greases
• Marine grease (for marine applications only)
Tapes
• POE cold shrink (maximum 49.2 mm or 1.9 in inner
diameter before shrinking) or self-amalgamating tape
• UV-resistant vinyl tape
• Electrical insulation putty
Mounting Hardware (Wall/Tower Only)
• Four 1/4" × 1/2" HEX chipboard screws
• Four 1/4" flat washers
• Four 1/4" spring washers
Chapter 2
Installing the Subscriber Station
Section 2.8,
7
Advertisement
Table of Contents
