Table of Contents
Advertisement
RUGGEDCOM WIN5137
Installation Guide
1.
Review the relevant certification information for any regulatory requirements. For more information, refer to
Section 5.1,
"Approvals".
2.
Unpack and inspect the subscriber station components. For more information, refer to
"Unpacking the Subscriber
3.
Mount the subscriber station to a pole, wall or tower. For more information, refer to
the Subscriber
4.
Install and connect the antenna(s). For more information, refer to
5.
Assemble the PoE cable. For more information, refer to
6.
Make sure the subscriber station is grounded. For more information, refer to
Subscriber
Station".
7.
Connect the subscriber station to a power source and the network. For more information, refer to
"Connecting Power and
8.
Seal all cable connections. For more information, refer to
Station".
9.
Configure the subscriber station. For more information, refer to
Station".
Section 2.2
Unpacking the Subscriber Station
The following items are included in the RUGGEDCOM WIN5137 package:
• RUGGEDCOM WIN5137 Subscriber Station
• RUGGEDCOM WIN1010 AC Power Injector
• 2 × Radio Frequency (RF) antenna cables, 5 m (16.4 ft) long
• Pole/wall/tower mounting kit
• RJ45 PoE connector kit
When unpacking the subscriber station, do the following:
1.
Inspect the package for damage before opening it.
2.
Visually inspect each item in the package for any physical damage.
3.
Verify all items are included.
If any item is missing or damaged, contact Siemens for assistance.
Section 2.3
Required Tools and Materials
The following tools and materials are required to install the RUGGEDCOM WIN5137:
Kits
• Class I, Division 2 Kit (P/N MKIT0090) – For hazardous
locations only
Unpacking the Subscriber Station
Station".
Station".
Data".
Section 2.7, "Installing the
Section 2.9.4, "Assembling the PoE
Section 2.8, "Grounding the
Section 2.10, "Weatherproofing the Subscriber
Section 2.11, "Configuring the Subscriber
Greases
• Marine grease (for marine applications only)
Chapter 2
Installing the Subscriber Station
Section 2.2,
Section 2.6, "Mounting
Antennas".
Connector".
Section 2.9,
7
Advertisement
Table of Contents
