Table of Contents
Advertisement
Installing the Device
2.3 Connecting the Failsafe Alarm Relay
2.
2.3
Connecting the Failsafe Alarm Relay
The failsafe relay can be configured to latch based on alarm conditions. The NO
(Normally Open) contact is closed when the unit is powered and there are no active
alarms. If the device is not powered or if an active alarm is configured, the relay
opens the NO contact and closes the NC (Normally Closed) contact.
Note
Control of the failsafe relay output is configurable through RUGGEDCOM ROS. One
common application for this relay is to signal an alarm if a power failure occurs. For
more information, refer to the "RUGGEDCOM RS8000H Configuration Manual" for the
RUGGEDCOM RS8000H.
The following shows the proper relay connections.
12
1
2
1
Screw
1
Panel/DIN Rail Adaptor
2
Figure 2.4
Panel Mounting
Install the supplied screws to secure the adapters to the panel.
1
2
1
RUGGEDCOM RS8000H
Installation Manual, 11/2022, C79000-G8976-1022-07
Advertisement
Table of Contents
Need help?
Do you have a question about the SIMATIC NET RUGGEDCOM RS8000H and is the answer not in the manual?
Questions and answers