Advantech ASMB-822I User Manual page 59

 Console Redirection Settings
 Terminal Type
Select a terminal type to be used for console redirection.
Options available: VT100/VT100+/ANSI /VT-UTF8.
 Bits Per Second
Select the baud rate for console redirection.
Options available: 9600/19200/57600/115200.
 Parity
A parity bit can be sent with the data bits to detect some transmission errors.
Even: parity bit is 0 if the num of 1's in the data bits is even.
Odd: parity bit is 0 if num of 1's the data bits is odd.
Mark: parity bit is always 1. Space: Parity bit is always 0.
Mark and Space Parity do not allow for error detection.
Options available: None/Even/Odd/Mark/Space.
 Stop Bits
Stop bits indicate the end of a serial data packet. (A start bit indicates the begin-
ning).
The standard setting is 1 stop bit. Communication with slow devices may require
more than 1 stop bit.
Options available: 1/2.
 Flow Control
Flow control can prevent data loss from buffer overflow. When sending data, if
the receiving buffers are full, a 'stop' signal can be sent to stop the data flow.
Once the buffers are empty, a 'start' signal can be sent to re-start the flow. Hard-
ware flow control uses two wires to send start/stop signals.
Options available: None/Hardware RTS/CTS.
49 ASMB-822I User Manual