Handling And Care; Mixing Controls For Ch 1 And Ch - Numark MATRIX2 Operating Instructions Manual

HANDLING AND CARE

Location
Install the mixer in a well-ventilated location where it will not be exposed to high temperatures or
humidity. Do not install the mixer in a location that is exposed to direct rays of the sun, or near stoves or
radiators. Excessive heat can adversely affect the cabinet and internal components. Installation of the unit
in a damp or dusty environment may also result in a malfunction or accident. (Avoid installation near
cookers etc., where the unit may be exposed to oily smoke, steam or heat.)
Cleaning the Unit
Use a polishing cloth to wipe off dust and dirt.
Do not spray any cleaners or lubricants into the mixer faders. This may damage the mixer and will void
the product warranty.
When the surfaces are very dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six
times with water and wrung out well, then wipe again with a dry clothe.
Do not use furniture wax or cleaners.
Never use thinners, benzene, insecticide sprays or other chemicals on or near this unit, since these may
damage the surface and finishes.
Condensation
When this unit is brought into a warm room from previously cold surroundings or when the room
temperature rises sharply, condensation may form inside, and the unit may not be able to attain its full
performance. In cases like this, allow the unit to stand for about an hour or raise the room temperature
gradually.
PAGE 3 HANDLING AND CARE