Inputs And Outputs - Numark MATRIX2 Operating Instructions Manual

CONTROLS

9. Inputs and Outputs

CH-1 and CH-2 Phono/Line Stereo Inputs
Each channel has a selectable phono level input (phonograph level/line level) and a line level input. The
line level input is used to connect CD players and other line level devices. When connecting a turntable to
the phono input, the switch must be set to "PHONO" instead of "AUX." When this switch is set to "AUX",
you can connect a line level device to the mixer (CD player, etc.) Please note that many turntables need
to be grounded to the mixer with a ground wire to prevent hum and excessive noise (see "GND.") It is
also recommended that the mixer be turned off before connecting and disconnecting any sources to the
inputs of the mixer.
WARNING: The Input Level Switch on the rear panel of the mixer must be set to "AUX" when connecting
line level devices. Failure to do so will result to damage in the mixer.
"Master" (Main Stereo Output)
This RCA output is for connecting an external device such as a PA system, powered monitors or a home
stereo. The level of the master stereo output signal increases as the "master" volume control is increased.
"Zone" (Auxiliary Stereo Output)
This RCA output is for connecting a secondary external device such as a booth monitor or second stereo
output. The level of the booth output signal will increase as the "Booth" volume control is increased.
"Rec" (Recording Level Stereo Output)
This RCA output is for connecting an external recording device such as a CD Recorder, MD Recorder or a
Tape Deck. The level of this signal is not affected by "master" volume or "booth" adjustments but is
affected by all other controls.
"GND" (Grounding Lug)
This screw connector should be used to secure any devices connected to the mixer that need to be
grounded. Most turntables that are connected to the mixer will need to have a ground wire that is
designed to connect to the mixer to eliminate hum and noise.
"Player A/B" (Fader Start Eighth Inch Terminals)
These two eighth inch terminals allow Fader/Remote Start Compatible devices (Numark CD Players) to be
connected to the unit using eighth inch fader start cables (not included.) Any connected device can then
be remotely started using the Crossfader (Section 7 "Special Crossfader Related Features.) "Fader Start"
must be switched to the on position for this feature to work properly.
NOTE: These terminals are only compatible with Digital Pulse Style Reception Devices
PAGE 15 INPUTS AND OUTPUTS