Customizing And Servicing Your Mixer - Numark MATRIX2 Operating Instructions Manual

CONTROLS

10. Customizing and Servicing Your Mixer

Replacing the Crossfader
This mixer features a replaceable Crossfader. The Crossfader can be
removed from the mixer by loosening the two screws at the endpoints of the fader (See illustrations at
right.) Follow the steps below for removing the top panel to have access to the Crossfader.
Customizing the Direction of the Input Selector Switches
This mixer features multi directional Input Switches that can be removed and rotated to one of eight
positions (See illustrations at right.) Each Input Selector Switch is secured to the mixer by two adjacent
screws. Be sure to make note of the current switch position and the new switch positions before rotating
the switches to prevent any uncertainty before re-securing the top panel. Follow the steps below for
removing the top panel to have access to the Input Selector Switches.
Removing the Top Panel
1. Unplug the mixer and set it on a flat surface.
3. Remove the four screws that secure the
top panel using a #2 Philips Screwdriver.
PAGE 17 CUSTOMIZING + SERVICING YOUR MIXER
CAUTION!
BEFORE REPLACING ANY PARTS, IT IS EXTREMELY
IMPORTANT TO UNPLUG THE MIXER FROM ITS
POWER SOURCE.
2. Remove the Three Fader Knobs.
4. Carefully remove the top panel.