Numark MATRIX2 Operating Instructions Manual page 19

Replacing the Crossfader
1. After removing the top panel, remove the
two screws that secure the crossfader
using a #2 Philips Screwdriver.
Customizing the Direction of the Input Selector Switches
1. After removing the top panel, remove the
two screws that secure the selector switch
you want to rotate using a #2 Philips
Screwdriver.
CUSTOMIZING + SERVICING YOUR MIXER
2. Carefully slide the crossfader out of the
mixer chassis, and unplug the harness
from the bottom of the part. Replace the
crossfader, refasten the two screws that
hold the crossfader in place.
3. Resecure the top panel, test the function,
and refasten the four screws that secure
the top panel.
2. Carefully slide the switch out of the
mixer chassis, and unplug the harness
from the bottom of the part. Rotate and
replace the switch, refasten the two screws
that hold the switches in place.
3. Resecure the top panel, test the function,
and refasten the four screws that secure
the top panel.
PAGE 18