Table of Contents
Advertisement
FLAT REMOTE CONTROL BATTERY SIGNAL
This function tells you that the remote control battery is almost depleted. You will notice that by
pressing any button on the remote control, the red LED on that remote control will flash
intermittently.It is recommended to use, Lithium 3V battery type CR2032. (See the 'BATTERY
REPLACEMENT' paragraph)
BATTERY REPLACEMENT
1
Open the remote by inserting a screwdriver between the two cases of the remote control (see
fig. 1). Lever to separate the two plastic cases.
2
Remove the printed circuit board (see fig. 2).
3
Remove used battery (fig. 3).
4
Insert the new battery taking care to only touch the sides of the battery (avoid touching the flat
surfaces of the battery and the printed circuit), into the centre compartment with the metal con-
tacts (see fig. 4).
5
Insert printed circuit board back into bottom case. Ensuring printed circuit board locates prop-
erly into locators in the bottom case.
6
Refit top of case and clip together.
15
Advertisement
Table of Contents
