Table of Contents
Advertisement
REMOTE CONTROL SPECIAL FEATURE
FLAT REMOTE CONTROL BATTERY SIGNAL
By using the "ALARM AUTO-DIAGNOSTICS" function, tells you that the remote control battery is
almost dead. When the alarm memory is checked, the LED on the dashboard will flash 9 times.
This means that the alarm has detected that the remote control battery is almost dead. At the same
time, you will notice that by pressing any button on the remote control, the red LED on that remote
control will flash intermittently. It is recommended to use 3V batteries, Lithium battery type
CR2032. (See the 'BATTERY REPLACEMENT' paragraph)
BATTERY REPLACEMENT
1
Open the remote by inserting a screwdriver between the two cases of the remote control (fig.
1). Lever to separate the two plastic cases.
2
Remove the printed circuit board (fig. 2).
3
Remove used battery (fig. 3).
4
Insert the new battery taking care to only touch the sides (not on the contact surfaces with the
metal contact and the printed circuit), into the centre compartment with the metal contacts (fig.
4).
5
Insert printed circuit board back into bottom case. Insuring printed circuit board locates prop-
erly into locators in the bottom case.
6
Refit top of case and clip together.
ISUT291-213UK.p65
15
11/05/2006, 18.53
Hide quick links:
Advertisement
Table of Contents
