LaserLine 862 User Manual page 3

OPERATING INSTRUCTIONS
You would have received from your installer two remote control handsets (see fig. 1) and have
been shown the location of the Status LED (fig. 2).
ARMING THE ALARM SYSTEM
Press button A of the remote control; arming is signalled by two
B
flashes of the indicator lights and two acoustic tones (excludable).
When the alarm has been armed the LED will illuminate
(pre-alarm time) and after 30 seconds will flash regularly (0.5
second ON and 2 seconds OFF). An alarm condition will not be
generated by the tamper or inclination sensors until the system
A
has been set for 30 seconds (pre-alarm time). C
Note: using button B within the pre-alarm time (30
seconds) it is possible to exclude the inclination sensor and/
fig. 1
or the siren for a setting period.
- Exclusion of the inclination sensor: press button B once, the
system confirms the programming with a single flash of the
indicator lights and a single acoustic tone (excludable).
- Exclusion of the siren: press button B twice within 2 seconds,
the system confirms the programming with two flashes of the in-
dicator lights and two acoustic tones (excludable).
The functions will be reset the next time the alarm is
armed using the remote control.
DISARMING THE ALARM SYSTEM
Press button A of the remote control; disarming is signalled by
fig. 2
one flash of the indicator lights and one acoustic tone (exclud-
able). If, during the armed period, the alarm did not sound, the
LED installed will extinguish (see "Alarm Trigger Signalling" - page 7).
3