LaserLine 862 User Manual page 5

SENSOR SELF-TESTING
SELF TEST FUNCTIONS
During the pre-alarm time (30 seconds), the LED will remain constantly ON, allowing you to perform
silent testing and verify the correct function of the tamper and inclination sensors. At the end of the pre-
alarm time (30 seconds), the LED will flash regularly (0.5 second ON and 2 seconds OFF).
HOW TO SELF TEST THE FOLLOWING DETECTION FEATURES ON THE ALARM
The following features depend on the type of motorcycle and insurance criteria's. Please consult your
alarm installer regarding the tamper detection applying to your motorcycle.
STANDARD INSTALLATION DETECTION
INCLINATION SENSOR
Arm the alarm by remote control; The LED will be constantly ON. Changing the orientation of mo-
torcycle will cause the LED to blink off for 1 second indicating that detection occurred.
IGNITION SENSOR
Arm the alarm by remote control; any attempt to start the motorcycle by switching on the ignition will
cause an immediate alarm condition.
SELF-POWER SENSOR
Arm the alarm by remote control; Removal of the alarm system fuse or disconnection of motorcycle
battery will cause an immediate alarm condition.
Note: For servicing of motorcycle battery, disarm the alarm before disconnecting battery. Reconnect-
ing the power to the alarm within 6 minutes, will cause the alarm to automatically enter into Garage
Function. Reconnecting the power to the alarm after 6 minutes, will cause the alarm to remain in the
disarm state.
5