Battery Saving Features - LaserLine 862 User Manual

Automatic Sleep Mode
The alarm system incorporates an automatic sleep mode which conserves the charge of the motorcycle's
battery whilst the motorcycle is not in use. This feature is activated automatically if the motorcycle is
not used for 3 consecutive days (72 hours). In this mode, the alarm will not respond to the remote controls
and the LED will not flash. All sensors are still armed.
Garage Function
This function allows you to manually activate the sleep mode with only the immobilisation activated.
To activate this function proceed as follows:
1) Disarm the alarm system.
2) Turn the ignition key ON.
3) Press and hold button B of a functioning remote control.
4) Turn the ignition key OFF whilst maintaining the activation of button B on the remote control.One
long acoustic tone and one long flash of the indicator lights will signal the activation of the Garage
Function.
5) Release button B of the remote control.
To "wake up" the alarm, simply turn ON the ignition key and press any button on a remote control or
enter the secret code within 10 seconds.
When either of these functions are active, switching ON the ignition key will cause the system to generate
brief and repeated acoustic tones, whilst flashing the LED. If a button is not pressed or the secret code
is not entered within 10 seconds the alarm will automatically arm and instantly sound an alarm condition.
If this occurs, press button A or enter the secret code to cancel the alarm condition (with or without ignition
key ON). When either of these functions are active, the current draw is less than 0.5 mA.
Note:
- Passive immobilisation is not affected by Automatic Sleep Mode or Garage Function and will still
be active under these conditions.
- If optional radio transmitting "infra-red garage sensor" or "garage door contact switch" are
10

BATTERY SAVING FEATURES