LaserLine 862 User Manual page 11

programmed into the alarm system Automatic Sleep Mode will not activate.
Attention: to maintain the motorcycle's own battery in a fully charged condition, it is recom-
mended to run the engine periodically (once every 4 weeks) or if the motorcycle is being stored for
longer periods, then the battery should be maintained with a dedicated mains charger. Failure to
maintain the battery may result in the battery being completely depleted and requiring replace-
ment.
REMOTE CONTROLS AND EMERGENCY PIN CODE FEATURES
SELF-LEARNING OF REMOTE CONTROL CODES
The alarm comes with 2 remote controls that are already coded. To code another remote control or
to cancel one that is lost/stolen, it is necessary to have one original functioning remote control.
Then proceed as follows:
1) Disarm the alarm system.
2) Turn the ignition key ON.
3) Press and hold button A of a functioning remote control.
4) Turn the ignition key OFF whilst maintaining the activation of button A on the remote control and
then release button A.
5) The LED mounted on the motorcycle will flash 10 times, then turns on and remains on, indicating
the self-learning condition.
6) Press button A of the original remote control followed by the next remote controls you wish to
code. Acceptance of the code of each remote control is indicated by the LED extinguishing for
1 second and then re-illuminating.
7) After learning the last remote control wait 10 seconds. The alarm will indicate an emergency
pin code by generating acoustic tones, in synchronisation with the flashing of the LED (see next
section on emergency pin code). It is important to make a note of this pin code as it may
change from the original code displayed in the rear of these instructions. After the emergency
pin code has been displayed the alarm will automatically arm if the ignition is not switched
ON.Verify the function of all the remote controls at the end of this procedure. Any remote
control, lost or stolen will be cancelled from the memory of the alarm.
11