LaserLine 862 User Manual page 16

*OPTIONAL MAGNETIC/INFRA-RED GARAGE SENSORS
The optional Magnetic contact switch (800) and the Infra-red sensor (801) can be installed in your
garage/shed, to give added protection to your motorcycle whilst being stored. The sensors have
their own built-in radio transmitters that can transmit a signal to your alarm of up to a distance of 5
metres from the motorcycle. This distance can change because of external conditions (sensor
battery condition, atmospherics, radio transmissions etc). When a sensor detects, a radio signal is
sent to the alarm to sound an alarm condition. If you have purchased additional sensor/s for your
garage/shed from your installer and they have not already programmed the sensor/s for you, the
following procedure must be performed.
SELF-LEARNING PROCEDURE
The 800/801sensors have to be self-learnt into the alarm system like the remote controls.
To carry out the self-learning procedure, ensure batteries in the sensors are disconnected and all
functioning remote controls are available. Then proceed as follows:
1) Disarm the alarm system.
2) Turn the ignition key ON.
3) Press and hold button A of a functioning remote control.
4) Turn the ignition key OFF whilst maintaining the activation of button A on the remote control and
then release button A . The LED mounted on the motorcycle will flash 10 times, then turns on and
remains on, indicating the self-learning condition.
5) Press button A of the original remote control followed by the next remote controls you wish to
code; connect the battery terminals (fig.1/fig.4) of each magnetic contact or the infra-red
sensor; the LED on the sensor will light for 2 seconds; while the LED of the alarm will turn OFF
briefly confirming the self-learning.
6) After learning the last magnetic contact/infra-red sensor wait 10 seconds. The alarm will indi-
cate an emergency pin code by generating acoustic tones, in synchronisation with the flashing
of the LED (see "EMERGENCY PIN CODE"). It is important to make a note of this pin code as
it may change from the original code displayed in the rear of these instructions. After the
emergency pin code has been displayed the alarm will automatically arm if the ignition is not
switched ON. Verify the function of all the remote controls/magnetic contact/infrared senors at
16