LaserLine 862 User Manual page 13

On the example, the Pin Code to note at the end of these instructions would be 5 6 0 5 4.
It is imperative to note on a piece of paper this Emergency Pin Code, if it is different from
the original pin code displayed in the rear of these instructions. This pin code must then be
stored in a secure location. Note: if you intend to leave these instructions on the motorcycle,
the pin code in the back of these instructions should be removed for safe keeping.
This emergency code is derived from the last remote control/garage sensor memorised when you self-
learn a new remote control. If you want to change the pin code from the original code, you may have
to follow the self-learning procedure more than once alternating the first remote control until a new pin
code is given.
HOW TO DISARM THE ALARM USING THE EMERGENCY PIN CODE
If the remote control does not work correctly, then the following emergency procedure may be used
to disarm the security system temporarily:
1) With the alarm armed or passively immobilised, cause an alarm condition by turning the ignition
key to the ON position until the alarm starts to sound.
2) When the alarm starts to sound turn ignition key OFF.
3) The alarm will sound for 30 seconds and will then stop sounding. Then the LED located on the
motorcycle will come ON (illuminate). Within 4 seconds, switch ON/OFF the ignition key for 1
second.
4) After 2 seconds, the LED/Alarm will start to flash/beep. The alarm is now ready to accept the
Emergency Pin Code, displayed at the end of these instructions.
5) For each digit of the pin code, the LED/Alarm will flash/beep 10 times. You must switch ON the
ignition key for 1 second at the same time of the corresponding flash/beep. Turn OFF the ignition
key and start to count the next digit value and repeat until all 5 pin code digits have been inputted.
6) If the emergency pin code is correct, the alarm will disarm signalled by one flash of the indicator lights
and one acoustic tone. If not, the alarm will remain armed and steps 1-5 will have to be repeated
again.Once the alarm is disarmed, turn the ignition key ON within 30 seconds to enable starting of
the engine. If the ignition is not switched ON the alarm system automatically enters the "SELF-
LEARNING OF REMOTE CONTROL CODES" function at step 5. This allows you to program new
remote controls if all remotes are lost and to clear the "secret code" if you have forgotten your sequence.
13