360 Vision Predator ULTRA Installation & Configuration Manual page 18

Predator ULTRA Installation Manual V2.1.25.3
Camera current draw table.
Power Up
Idle
(No Lamps)
PTZ/Wiper
(No Lamps)
Idle
(IR Lamps)
PTZ/Wiper
(IR Lamps)
Idle
(White Lamps)
PTZ/Wiper
(White Lamps)
Voltage at PSU
Voltage at Camera
(PTZ/IR Fast tour)
Current/Voltage test at
cable length (1.5mm²)
Ethernet connections between Predator PSU and Predator that is fitted with HMA.
The Ethernet connection uses standard CAT5, CAT5e or CAT6 cables fitted with RJ45 connectors.
Gain access to connectors in the HMA
• Ensure that the fixed part of the HMA is securely bolted to the top of the pole.
• The hinged part of the HMA (Hinged Mount Adapter) is fastened to the fixed part using three M8x25
long hex head bolts. Use a spanner (13mm) to remove the three bolts. Each bolt is fitted with a
split spring lock washer, a plain metal washer (which prevents the split washer from damaging the
fibre washer) and a fibre washer (which prevents the paint on the hinged part from being damaged
unnecessarily.
• Open the hinge taking care that the gasket is not damaged and support the weight of the Predator.
Gently open the HMA until the lanyard is able to take the weight. If the lanyard appears to support the
weight of the Predator, there is no need to continue to support the Predator. The connection circuit
board can now be seen.
IR80/
No Lamps
SIR110
1.2A 1.2A
0.83A 0.83A
1.45A 1.45A
N/A 2.3A
N/A 3.1A
N/A N/A
N/A N/A
30Vdc 30Vdc
28.5Vdc
27Vdc
(No Lamps)
40m 40m
RJ45 CAT5, CAT5e, CAT6 Cable
Pin 1 White with Orange Band
Pin 2
Pin 3 White with Green Band
Pin 4
Pin 5 White with Blue Band
Pin 6
Pin 7 White with Brown Band
Pin 8
© 360 Vision Technology Ltd.
IR110WL/ IR130/
SIR140WL SIR160
1.2A 1.2A
0.83A 0.83A
1.45A 1.45A
2.3A 3.1A
3.1A 3.8A
2A N/A
2.7A N/A
30Vdc 30Vdc
27Vdc 27Vdc
40m 40m
Orange
Blue
Green
Brown
IR175SW/
SIR250WL
1.2A
0.83A
1.45A
3.1A
3.8A
2A
2.7A
30Vdc
27Vdc
40m
Signal
Tx+
Tx-
Rx+
Rx-
Page 18
IR200/
SIR275
1.2A
0.83A
1.45A
3.1A
3.8A
N/A
N/A
30Vdc
27Vdc
40m