Step 3: Receiving (Restoration) End Of The Product Signal Output Wiring - Ebyte K62-DL20 User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd. K62-DL20 User Manual
(2) Notes.
1, the user needs to confirm that the sensor belongs to the several-wire system sensors, and connected with wires in
accordance with the wiring schematic.
2, the terminal connection wire, pay attention to the terminal conductive part can not be pressed to the wire insulation
layer, so as to avoid poor contact, causing abnormalities.
(For more details, please see the "Frequently Asked Questions and Solutions (FAQ)" section)

2.2.3 Step 3: Receiving (restoration) end of the product signal output wiring

(1) In accordance with Figure 2-3 below, connect the AO and GND of the reduction end of this product K62-04 to the
signal receiving "positive" and "negative" terminals of the analog acquisition equipment with wires respectively (or
connect to a multimeter, note that the multimeter position needs to be set to greater than 20mA current level, the "red
meter pen" connected to the product "AO", "black meter pen" connected to the product "GND ("), and tighten the screws
on the plug-in terminals of this product. (This part of the wiring schematic see: "analog reduction output (AO) wiring")
(2) Notes.
1, the output of this product is an active signal: constant current source output, the load resistance value needs to be ≤
500Ω.
2, using a multimeter measurement, pay attention to the multimeter gear must be correct, so as not to damage the external
table, or lead to large measurement errors.
3, the terminal connection wire, pay attention to the terminal conductive part can't be pressed to the wire insulation layer,
so as to avoid poor contact, causing abnormalities.
(For more details, please see the "Frequently Asked Questions and Solutions (FAQ)" section)
Figure 2-3 Connecting a signal generator tool (can be a sensor and multimeter)
18
Copyright ©2012–2021，Chengdu Ebyte Electronic Technology Co.,Ltd.