Nortel V2 Release Note page 10

10
Customers who are running 2.0.3, 2.0.4 or 2.0.7 and before with pmp or
backplane throughpaths configured must use the upgrade and installation
procedure described in Appendix A.
New firmware for the External Synchronization Card has been introduced
which improves the locking characteristics to the BITS timing source. A
version 9 listed under configuration esi show will be displayed for ESI cards
containing the new updated firmware.
Fast SPVC re-routing in the event of a cable failure has been introduced for
OC3 and J2 Netmods.
The reset command introduced in Vector Release VSS2.0.4 under operation
linkmod has been replaced in VSS2.0.8 with the command operation netmod
reset. This VMI command provides the ability re-initialize the specified
netmod. Note: Invoking this command causes service disruptions to all ports
on the affected netmod.
Users who wish to install or migrate to MDP version 10.3.1 should refer to the
Magellan Data Provider User Guide, NTP 241-6001-309 for installation and
operation instructions. MDP 10.3.1 (version MDP103Pax) requires the Solaris
operating system and application of patch 10.3-14.
Magellan Vector 2.0 Release Note, Issue 1.9.1