Table of Contents
Advertisement
Setup of Registered Media
Setup of Sheet Media
Load the sheet media on the printer. When the loading is finished, [Output possible.] is displayed as the
status. This work is referred to as "Setup of Media."
1. A: Determine the positions of the media (opaque media).
This section describes how to use the suction fan to prevent media skewing.
By default, [Skewing Correction Support at Setup] is set to [Enable].
Procedure
1.
Tap
on the operation panel.
The sub power is switched on.
2.
Set the [Skewing Correction Support at Setup].
(1)
Tap
(2)
[Preferences]>[Skewing Correction Support at Setup]
(3)
Select [Enable] and tap [Save].
(4)
Tap
3.
Open the front cover.
4.
Move the media clamps to the outside of the grit rollers on the left and right edges respectively.
5.
(Move to the rear of the printer.) Release the locking mechanisms of the media holders, and then draw
them to the left and right ends respectively.
78
Basic Operations
.
to go back to the original screen.
Advertisement
Table of Contents
