Procedure 3-6
Using the One Time Backup option
Use this procedure to add, edit, or delete a one time backup of a controller.
Note: You cannot schedule a backup if a backup is in progress. The state
of the controller must be idle to schedule a backup.
Refer to Figure 3-5, The One Time Backup tab on page 3-19.
Requirements
Before you start, you must
•
be at the Network Wide Backup & Restore window
•
select the One Time Backup tab
•
have admin privileges
Action
Step
1
2
3
4
Network Wide Backup & Restore User Guide 450-3101-031 Rel 1.0 Standard June 1999
Administration of Network Wide Backup & Restore 3-17
Action
Determine your action.
If you want to
add a one time backup
edit a one time backup
delete a one time backup
Highlight the controller, in the Controller List, for which you want to edit a one
time backup.
Go to step 4.
Highlight the controller, in the Controller List, for which you want to delete a
one time backup.
Click on Clear.
Click on Save.
Determine the fields you want to edit.
If you want to edit the
start date of the one time backup
start time of the one time backup
transfer rate of the one time backup
storage location of the backup
—continued—
Then go to
step 5
step 2
step 3
Then go to
step 5
step 6
step 7
step 8
NTP Update Issue 1 July 1999
3