3-30 Administration of Network Wide Backup & Restore
Procedure 3-11
Canceling an active controller
Use this procedure to cancel an active controller.
Requirements
Before you start, you must
•
•
•
Action
Step
1
Integrated Network Management
be at the Network Wide Backup & Restore window
select the Controller Status tab (refer to Figure 3-9, The Controller Status
tab on page 3-29)
have admin privileges
Action
Click on the Cancel button.
Note: Certain stages of a Backup or a Restore cannot be cancelled. A
Cancel command will fail if selected during one of these stages.
450-3101-031
—end—
Rel 1.0 Standard June 1999