Configuring and Troubleshooting Bay Dial VPN Services
•
•
•
•
For Each Remote Node
Record this information for each remote user authorized to dial in to the Dial VPN
network.
•
•
1-10
If the CPE router is a Bay Networks (or other non-Cisco) router, you
must configure an adjacent host on the CPE router. Fill in the following
information about the adjacent host.
-- What is the IP address of the adjacent host (that is, the next-hop router,
in this case, the gateway port)? ___________________________________
-- What is the IP address of the CPE router's network interface to the
adjacent host? ________________________________________________
-- What is the subnet mask of the adjacent host?
____________________________________________________________
-- What is the physical media access control (MAC) address of the adjacent
host (DLCI number)? __________________________________________
For the static route between the CPE router and the RADIUS client on
the gateway:
-- What is the IP address of the RADIUS client to which you want to
configure the static route?_______________________________________
-- What is its subnet mask? ________________________________________
For the static route between the CPE router and the remote node:
-- What is the IP address of the RADIUS client to which you want to
configure the static route?_______________________________________
-- What is its subnet mask? ________________________________________
What is the IP address of the RADIUS Server on the customer's home
network?
__________________________________________________________
User ID: ____________________________________________________
For which domain(s) is this user authenticated?
______________________________________________________________
__________________________________________________________
BayStream Multiservice Software Version 7.2
115623B Rev. 00