Radius Authentication Server; Dial Vpn Network Planning Worksheet - Bay Networks Baystream 7 Configuration And Troubleshooting Manual

Enterprise subscribers of this service must configure the CPE router to allow
routing to occur between the remote nodes and the hosts on the home network.
This means that a frame relay PVC, static route, and (if this is a Bay Networks or
other non-Cisco router) adjacent host designation must exist between the CPE and
the gateway router on the Dial VPN network.

RADIUS Authentication Server

The RADIUS server on the customer's network is a network access security
system. It uses a locally stored and maintained database to authenticate dial-in
user access requests. The RADIUS client of this server resides on the gateway.
The remote authentication server contains all user authentication and network
service access information. The gateway, acting as a RADIUS client, generates a
RADIUS authentication request to the appropriate RADIUS server. This request
contains the user authentication information. The gateway sends the request on the
mapped virtual circuit towards the CPE, which receives the authentication request
and forwards it to the RADIUS server.
Once the user is authenticated, the RADIUS server grants access to the remote
node by returning an authentication accept packet with RADIUS authorization
information to the gateway through the CPE. The gateway then forwards the user
authorization to the NAS, which initiates an IP tunnel to the gateway using Mobile
IP protocol mechanisms.

Dial VPN Network Planning Worksheet

This section consists of a network planning worksheet. Filling in this information
will give you a handy reference for configuring Dial VPN for your network. As
part of your worksheet, you should also draw a sketch of your network, indicating
the IP addresses of each device and also showing the frame relay PVC, static
route, adjacent host, and DLCI information.
The worksheet contains space for the information you will need when running the
BayStream Quick-Start installation script (install.bat). The installation script
prompts you for network information to connect the router or BayStream platform
to the IP network.
Many steps in the installation script suggest default values. Accept the default
values unless you have a reason to change them.
115623B Rev. 00 BayStream Multiservice Software Version 7.2
Planning for Dial VPN
1-7