Nortel CallPilot Mini Quick Start Manual page 13

3 Configure the Quick Install parameters for a CallPilot Mini according to following table.
Table 6 Quick Install Wizard parameters for a CallPilot Mini
Field name Description
IP Address Enter the IP Address for the CallPilot Mini. If you do not know the IP Address, contact your
network administrator.
This is the IP Address you will use to access the CallPilot Mini using CallPilot Manager.
Changes to the IP Address take effect when you reboot the CallPilot Mini.
If this is a re-install, the IP Address shows the current settings, not the factory default.
Subnet Mask Enter the Subnet Mask for the CallPilot Mini. If you do not know the Subnet Mask, contact your
network administrator.
Changes to the Subnet Mask take effect when you reboot the CallPilot Mini.
If this is a re-install, the Subnet Mask shows the current settings, not the factory default.
Primary DNS Enter the IP Address of the Primary DNS server that CallPilot Mini uses. If you do not know
the IP Address, contact your network administrator.
The Primary DNS server allows you to use domain names, such as www.nortelnetworks.com,
instead of IP addresses when accessing a site.
Note: If you do not use DNS, leave this box blank. CallPilot applications, such as Digital
Networking, can use a DNS server even if you leave this box blank.
Secondary DNS Enter the IP Address of the Secondary DNS server that CallPilot Mini uses. If you do not know
the IP Address, contact your network administrator.
CallPilot Mini uses the Secondary DNS server if it cannot contact the Primary DNS server or if
the domain name is not listed in the Primary DNS server.
Note: If you do not use DNS, leave this box blank. CallPilot applications, such as Digital
Networking, can use a DNS server even if you leave this box blank.
Default Gateway Enter the IP Address of the default next-hop router. If you do not know the IP Address, contact
your network administrator.
Note: If you do not require a next-hop router, leave this box blank.
Digits per Extension Select the length of the extension number in digits.
Attendant DN
Enter the directory number of the attendant. You can enter a number from 1 to 7 digits long.
Primary Language Select the default language that is used for voice prompts, text messages, and the
Auto-Attendant.
You can change the language of individual mailboxes by assigning a different Class of Service
to those mailboxes.
Country Select the country in which the CallPilot Mini is installed.
The country you select determines several country specific settings such as the telephone
number length, mailbox login sequence and Call Progress Tone Detection. You must select the
country that the CallPilot Mini is in to ensure proper operation.
The default country is North America.
Companding Type Select the companding law that is used by your Meridian 1 switch and the public switched
telephone network.
You can select A-Law or M-Law.
Warning:
If you enter an FQDN in the IP Address box, you must ensure that the
FQDN for the CallPilot Mini is in the same subnet as is specified by the Subnet Mask
and the Default Gateway IP address. If you enter an FQDN that is not in the same
subnet, you may cause the CallPilot Mini to continuously reboot. To correct this
problem, use the serial interface to change the IP address of the CallPilot Mini. For
more information, refer to
Initializing the CallPilot Mini
"Changing the IP address using a serial cable" on page
CallPilot Mini Quick Start Guide
13
10.