Nortel CallPilot Mini Quick Start Manual page 11

The prompt
To change any of this, press any key within 5 seconds
Note: It will take approximately one minute for this prompt to appear.
7 Press the Enter key.
Note: If you do not press a key within 5 seconds of this prompt appearing, repeat
steps 5 and 6.
The prompt
(M)odify any of this or (C)ontinue?
8 Press the M key and press the Enter key.
The prompt
Do you want a LAN interface?
9
Press the Y key and press the Enter key.
The prompt
This board's LAN IP Address (0.0.0.0 = RARP)
10 Type the IP address for the CallPilot Mini in a valid dotted format and press the Enter key.
The prompt
Subnet mask for LAN (0 for none)
11 Type the Subnet Mask for the CallPilot Mini in a valid dotted format and press the Enter key.
The prompt
Should there be a default gateway for packet routing?
12 If the CallPilot Mini needs a next hop router, press the Y key and press the Enter key.
If the CallPilot Mini does not need a next hop router, press the N key, press the Enter key and
go to step 15.
The prompt
IP address of default gateway?
13 Type the IP address of the next hop router in a valid dotted format and press the Enter key.
14 Press the Enter key until the following prompt appears.
(M)odify any of this or (C)ontinue?
15 Press the C key and press the Enter key.
16 Connect the LAN cable to the Ethernet port on the CallPilot Mini.
You can now initialize the CallPilot parameters. For information about how to initialize the
CallPilot, refer to "Running the Quick Install Wizard" on page
Initializing the CallPilot Mini
appears.
appears.
appears.
appears.
appears.
12.
CallPilot Mini Quick Start Guide
11
appears.
appears.