Table of Contents
Advertisement
SETTING UP AND CONFIGURING THE DEVICE
For accessory card specifications, regulatory content, and installation information, refer to the appropriate product
page: www.multitech.com/brands/multiconnect-mcard.
Installing a Micro SD Card
You need:
Phillips screwdriver
MicroSD memory card
To install or replace the SD card:
1.
Disconnect power to the Conduit, if it is connected.
2.
At the front of the Conduit, remove the screw that secures the MultiTech nameplate.
3.
Locate the SD card at the left side of the opening on the underside of the PC board.
4.
If an SD card is already installed, gently push on the card to release it from its setting and remove it from
the housing with your fingers.
5.
With the new SD card contacts facing up and toward the interior of the device, gently push the card into
the slot to secure it.
6.
Reattach the MultiTech nameplate to the housing using the screw removed in step 2.
Installing a Battery
The battery is located in the Conduit housing.
You need:
Phillips screwdriver
If replacing a battery, non-metal tweezers or similar object
CR1632 standard coin lithium battery
To install or replace the battery:
1.
If connected, disconnect power to the Conduit.
2.
At the front of the Conduit housing, remove the screw that secures the MultiTech nameplate to the
housing.
18
®
Conduit
Cat 4 for North America MTCDT-L4N1 Hardware Guide
Advertisement
Table of Contents
