Nortel 1000 Configuration Manual page 105

Figure 30
Zones web
Configuration using LD 117
A new Bandwidth Management zone is configured in LD 117 using the
NEW ZONE command. An existing zone can be modified using the CHG
ZONE command.
LD 117 Configure a new or existing Bandwidth Management zone.
Command
NEW | CHG ZONE <zoneNumber> [<intraZoneBandwidth> <intraZoneStrategy>
<interZoneBandwidth> <interZoneStrategy> <zoneIntent> <zoneResourceType>]
Copyright © 2005-2007, Nortel Networks
.
Configuring Bandwidth Management parameters 105
Description
Configure a new zone (NEW) or change (CHG) an existing zone, where:
• zoneNumber = 0-255
• intraZoneBandwidth = Available intrazone bandwidth (Kbit/s); Nortel
recommends this value be set to the maximum value.
• intraZoneStrategy = BB (Best Bandwidth) or BQ (Best Quality); Nortel
recommends this value be set to BQ.
• interZoneBandwidth =
— For Call Server zone = Maximum bandwidth usage (in Kbit/s)
allowed between peer Call Servers
— For Virtual Trunk zones = 1000000 (Kbit/s)
• interZoneStrategy = BB (Best Bandwidth) or BQ (Best Quality); Nortel
recommends this value be set to BB to conserve interzone bandwidth.
• zoneIntent = type of zone, where:
— MO = Main Office (Call Server) zone
— BMG = Branch Media Gateway (for branch office zones)
— VTRK = Virtual Trunk zone
• zoneResourceType = resource intrazone preferred strategy, where:
Nortel Communication Server 1000
Main Office Configuration Guide for SRG 50
NN43001-307 02.02 Standard
Release 5.0 3 December 2007