Oil Filter, Change - Volvo Penta TAD550GE Operator's Manual

47711096 09-2018 © AB VOLVO PENTA

Oil filter, Change

TAD550GE, TAD551GE, TAD750GE, TAD751GE
WARNING!
Hot oil and hot surfaces can cause burns.
NOTICE! Always follw the recommendation ofr oil
change intervals. Always change the oil filter at the
same time as the oil change. Refer to Oil Grade and
Oil Change Interval.
1 Clean the oil filter holder thoroughly to avoid dirt
entry when the new filter(s) is/are installed.
2 Remove the filter (1). Check that the gasket has not
been left behind on the engine.
NOTICE! Place a container under the filter so that
the oil spillage.
3 Apply a light coat of engine oil on the new oil filter
seal rings. Screw the filters on by hand until the
gaskets just touch the mating surface. Then turn the
filter a further half turn. Not more!
4 Start the engine and let it idle. Check that the oil
pressure is normal.
5 Stop the engine. Check that no oil leakage occurs
around the filters. Top up with oil as necessary.
NOTICE! Collect the old oil and old filters and hand
them toa re-cycling station for destruction.
Maintenance
57