Table of Contents
Advertisement
Maintenance
64
Oil Filter/By-pass Filter, Change
WARNING!
Hot oil and hot surfaces can cause burns.
1 Clean the oil filter bracket (2).
2 Remove all oil filters with a suitable oil filter
extractor (1).
3 Clean the mating surface of the oil filter bracket.
Make sure that no pieces of old oil seal are left
behind. Carefully clean round the inside of the
protective rim (2) on the oil filter bracket.
4 Put a thin layer of engine oil on the seal rings of the
new fuel filters.
5 Install the new oil filters. Tighten the filters ¾–1 turn
after they touch.
6 Top up with engine oil, start the engine and let it run
for 20-30 seconds.
7 Turn off the engine, check the oil level and top up
as required.
8 Check sealing round the oil filters.
47711210 01-2019 © AB VOLVO PENTA
Advertisement
Table of Contents
