Oil Filter/By-Pass Filter, Change - Volvo Penta 13L Operator's Manual

Maintenance
84

Oil Filter/By-pass Filter, Change

WARNING!
Hot oil and hot surfaces can cause burns.
1 Clean the oil filter bracket (2).
2 Remove all oil filters with a suitable oil filter
extractor (1).
3 Clean the mating surface of the oil filter bracket.
Make sure that no remnants of old oil seal are left
behind. Carefully clean round the inside of the
protective rim (2) on the oil filter bracket.
4 Put a thin layer of engine oil on the seal rings of the
new oil filters.
5 Install the new oil filters. Tighten the two full-flow
filters (on the right of the illustration) 1/2–3/4 of a
turn after they bottom. Tighten the bypass filter 3/4–
1 turn after it bottoms.
6 Top up with engine oil, start the engine and let it run
for 20-30 seconds.
7 Stop the engine, check the oil level and top up as
required.
8 Check the sealing round the oil filters.
47711089 09-2018 © AB VOLVO PENTA