Access Point Leds Do Not Light; Baystack Pc Card Leds Do Not Light - Nortel BayStack 650 User Manual

Table 7-2
in the BayStack 650 Access Point).
Table 7-2.
Color
Green
Amber

Access Point LEDs Do Not Light

If none of the LEDs lit when you apply power, do the following:
Check the power supply between the access point and the outlet.
1.
Try connecting the power supply directly to a wall outlet, not using an
extension cord or a power strip.
Check the Ethernet connection.
2.
Try another Ethernet cable or connect to another port. Turn the access point
off and then back on.
If necessary, install and activate an Ethernet device (10BASE-T hub or
3.
switch) and connect the access point to it.
Connect the access point to a 10Mbps port on the Ethernet device and
4.
turn the power on the access point off and then back on (100BASE-T
only).
If problems persist, contact Nortel Networks customer support. For
5.
contact details see http://www.nortelnetwork.com/servsup.com. Go to the
"BayStack Workgroup Products" category, and then use the "ERC" link.

BayStack PC Card LEDs Do Not Light

If the LEDs on the BayStack PC Card installed in the access point did not light,
try the following:
Re-seat the BayStack PC Card in the slot in the access point. Make sure
1.
that it is firmly seated.
Make sure that the PC card in the laptop computer you are trying to
2.
connect to is an 802.11 mode card.
203282-B
describes the LEDs on a BayStack 650 PC Card (that is, if it is installed
PC Card LED Descriptions
Activity Description
On There is a wired link from the access point to the network.
Blinking There is data transmission or data receipt activity occurring.
Diagnostics and Troubleshooting
7-5