Ending A Maintenance Session; Version Number; Port Status - Nortel Meridian Companion Installation And Maintenance Manual

113 Maintenance

Ending a Maintenance session

Version number

Port status

COMPANION 200 Installation and Maintenance Guide
2. Enter the Installer password. The default password is
¤flfl‹›› (or ÇØˆÏł I
3. If the password is correct, the display shows A.Configuration.
If the password is incorrect, the display shows Password:. Press
RETRY, and enter the password again.
4. Press * until the display shows C.Maintenance.
5. Press ^. The display shows 1.System Version.
To end a Maintenance session, press ®.
To report a problem with the COMPANION 200 system, you will
need to know which version of software your system is running. You
should record the version number in the COMPANION 200
Programming Record.
To verify the software version your system is running, follow these
steps:
1. Enter a Maintenance session.
2. Press * or & until the display shows
1.System Version.
3. Press ^. The display shows the version number of the
COMPANION 200 software.
4. To continue in Maintenance, press %.
The Port Status feature lets you:
• Identify any device or access line connected to the COMPANION
200. A device can be the Administration Terminal, a Base
Station, or a Remote Access Device (RAD).
• Verify the version number of a device for compatibility with the
system.
• Verify the state of a device or access line (for example, idle or
busy).
).
ł G
P0725810 Issue 3.0