Table of Contents
Advertisement
84 Appendix A Technical specifications
Figure 29 T1/E1 CSU/DSU WAN interface card (full-height card)
The connector on the T1/E1 CSU/DSU WAN interface card accommodates an
8-pin RJ-48 modular patch cord. These cables are sold as Category 5, or Ethernet,
cables.
Use cable that is wired in accordance with EIA-568-A wiring style. This wiring
style ensures that the transmit signal (pins 4 and 5) and the receive signal (pins 1
and 2) are carried on a twisted pair inside the patch cord. The use of factory made
patch cords is strongly recommended.
You connect the T1/E1 CSU/DSU WAN interface card to the service provider
network using a straight-through cable or a crossover cable, depending on how the
service provider wired its jack.
•
•
Table 23
Table 23 T1/E1 CSU/DSU cable pinouts for crossover connection
Standard-wired
end 8-pin male
1
2
3
4
NN46110-308 02.01
Note: Nortel does not supply the T1/E1 CSU/DSU WAN interface
cable with the WAN interface card.
For a straight-through connection, you can use a standard Category 5
(Ethernet) straight-through cable.
For a crossover connection, you cannot use a standard Category 5 crossover
cable. The T1/E1 CSU/DSU crossover cable and the Ethernet crossover cable
are not interchangeable.
provides the T1/E1 CSU/DSU cable pinouts for a crossover connection.
Signal name
RXDA<-TXDA
RXDB<-TXDB
not used
TXDB->RXDB
CS160012A
Pair number
and conductor
wht/org pair 2A
orange pair 2B
wht/grn pair 3A
blue pair 1B
Special-wired
end 8-pin male
5
4
3
2
Advertisement
Table of Contents
