Table of Contents
Advertisement
68 Chapter 5 Using recovery mode
1
NN46110-308 02.01
Restore the configuration:
To restore the factory default configuration or the backup configuration, do
one of the following:
•
Restore the factory default configuration by selecting Restore Factory
Configuration, then clicking Restore to return the VPN Router 600 to its
original factory default configuration. This option erases data contained
in flash memory and also in the configuration file.
Caution: Risk of configuration loss
If you select this option, you must rebuild your entire configuration
again from scratch
A message specifies the result of the Factory Configuration reset action.
•
Or, you can restore the gateway's previously backed-up configuration by
clicking Restore. If you previously chose to automatically back up the file
systems, then the Backup Server Host (or IP address) and Path Name,
User ID, and Password appear in the table.
Choose the Partial Backup option to restore the configuration files, log
files, or system files from a partial backup.
Click the radio button of the preferred backup server. The backed-up file
system, including software image and configuration files, from the latest
backup copy residing on the designated server is restored onto the hard
drive of your gateway.
You can use the same backup server for multiple gateways. Each gateway
creates a unique directory based on its serial number. The following
example shows the host, path, and serial number:
C:/software/backup/v101/SN01001
The serial number differentiates backup configurations from multiple
gateways that are saved on the same backup server. The serial number
uniquely identifies each gateway's backup data.
A blank row in the server backup field always appears to allow you to
manually enter a backup server in case you did not configure automatic
backup server locations.
Advertisement
Table of Contents
