Cisco Catalyst 9300 Series Hardware Installation Manual page 69

Installing a Switch
a) Stick the labels available with CAT-A-AIRFLOW kit on to each side of the switch as shown in the
following illustration. Make sure you align the holes in the labels with the screw holes in the chassis.
b) Secure the brackets to the chassis using the flat head screws provided with the bracket.
Note
Figure 31: Attaching the NEBS-Compliant Air Vent Label to the Switch
1
2
NEBS is supported only with four-point mounting.
Number-8 Phillips flat-head screws
19-inch bracket
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
Attaching the Rack-Mount Brackets
3 NEBS-compliant
CAT-A-AIRFLOW kit
- -
57