Network Module Port Configurations; C9300-Nm-2Q Module - Cisco Catalyst 9300 Series Hardware Installation Manual

Network Module Port Configurations

Network Module Port Configurations

C9300-NM-2Q Module

If you use a 40G QSFP module, the ports default to 40G interfaces. In this case, the 10G interfaces are displayed
but not used.
Table 23: C9300-NM-2Q Module with 40G QSFP Module
Interface
FortyGigabitEthernet1/1/1
FortyGigabitEthernet1/1/2
TenGigabitEthernet1/1/1
TenGigabitEthernet1/1/2
TenGigabitEthernet1/1/3
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
72
Figure 42: Installing the C9300X Network Module in the Switch
1 Ejector 2 Network module (C9300X-NM-8Y)
Action
Configure this interface
Configure this interface
Disregard
Disregard
Disregard
Installing a Network Module