Control Panel - Supermicro A+ Server AS -1115CS-TNR User Manual

Control Panel

Information LED
UID Button
BMC Reset
Feature Description
The unit identification (UID) button turns on or off the blue light function of the Information
UID Button LED and a blue LED on the rear of the chassis.
BMC Reset This button can also be used to
the front VGA port, if available.
Applies or removes primary power from the power supply to the server but standby power is
Power button
maintained
Information LED Alerts operator to several states, as noted in the table below.
Indicates network activity on LANs when flashing; defaults to the first two ports of the CPU1
NIC LEDs
AIOM
HDD LED Indicates activity on the storage drives when flashing.
Steady on – Power on
Blinking at 4Hz – Checking BIOS/BMC integrity
Power LED Blinking at 4Hz and "i" LED is blue – BIOS firmware updating
Two blinks at 4Hz, one pause 2hz and "i" LED blue – BMC firmware updating
Blinking at 1Hz and "i" LED red – Fault detected
USB Ports Two USB ports
Color, Status
Red, solid
Red, blinking at 1Hz
Red, blinking at 0.25Hz
HDD LED
Power LED
NIC LEDs
Figure 1-2. Control Panel
Control Panel Features
reset the BMC and will disable the rear VGA port to enable
Information LED
Description
An overheat condition has occurred.
Fan failure, check for an inoperative fan.
Power failure, check for a non-operational power
supply.
11
Chapter 1: Introduction
Power Button
USB Ports